LinkECU Sensors/Cables/Gauges

CAN LAMBDA SENSOR KIT

The CAN-Lambda Sensor kit’s ability to measure the proportion of oxygen in exhaust gases makes it a essential tool for accurately tuning fuel mixtures as well as allowing your ECU to make tuning adjustments on the fly.

Being fully digital the CAN Lambda’s powerful LSU 4.9 sensor will eliminate any loss of signal, risk’s, delays, or errors that analog sensors have. The CAN-Lambda sensor never requires free air calibration.

Box Contents

• CAN Lambda device
• Bosch LSU4.9 Sensor
• Deutsch 4-Way Connector Kit
• O2 Bung and Plug
• 2 Large Stickers
• 2 Small Stickers
• Quick Start Guide

CANJST4

Required to add CAN communications & power to recently released G4X Plugin ECUs which have the new 4 Pin powered CAN connector (not the older 5pin CAN connector). Plugs directly into the socket on the ECU PCB, provides CAN and a protected 12V supply to allow easy connection of CAN accessories.

Suitable for powering a CAN Lambda, Dash, EGT amplifier or other similar low powered CAN devices which have a total continuous current draw of <3A.

Note: there are two versions of this cable; both function the same.

Compatible Plug-Ins:

• 219-4000 – Plug-In ECU G4X Mazda RX7 Series 7-8 (V1.4 onwards)
• 228-4000 – Plug-In ECU G4X Subaru WRX V5-6
• 233-4000 – Plug-In ECU G4X Honda S2000 AP1
• 235-4000 – Plug-In ECU G4X Toyota JZX90X
• 237-4000 – Plug-In ECU G4X Honda HC20X Type-R DC5/RSX
• 238-4000 – Plug-In ECU G4X Subaru WRX11
• 239-4000 – Plug-In ECU G4X MX5NB2X
• 240-4000 – Plug-In ECU G4X MX5NB1X

  Specs
  DTM4 Male to JST4. 12V and GND Terminated to JST4. Length 300mm

  DTM4 Pin Out
  Pin 4: CAN H
  Pin 3: CAN L
  Pin 2: Ground
  Pin 1: 12V

TUNING CABLE

Link CAN to USB Tuning Cable. Used to connect the ECU to a computer via USB. A CAN to Serial cable is also available.

PCB CABLE

Required to add CAN/Serial communications to G4+/G4X Plugin ECUs. Plugs directly into ECU PCB header. Use the Link CANF connector (purchased separately) to connect.

Compatible with:

• Link G4X Storm
• Link G4X and G4+ Fury
• Link G4X and G4+ Xtreme
• Link G4+ Thunder
• All Link G4+ and G4X Plugin ECUs
• Link G4+ Storm Black/Blue/Silver
• Any older Link ECU utilising the Link 6 Pin CAN connector
• Vipec V88 and i44
• Link G3

CAN F PLUG

Field Installable CAN Plug – Can be used to wire in to the 6 pin CAN port on Link G4/G4+/G4X ECUs that have a round 6 pin CAN commu